|
|
|
|
|
Didactics
Drive and Control Technology Seminars
|
|
|
Training Specific to Customers and Projects:
In addition to the extensive range of training courses and seminars in Germany, Bosch Rexroth Schweiz AG offers training courses specific to customers and projects either in Otelfingen or at your premises. Courses are tailored to your requirements.
- Drive technology (start-up, service)
- SPS (project planning, programming, start-up, service)
- CNC (project planning, programming, start-up, service)
- Robot controls (project planning, programming, start-up, service)
- Bus systems (project planning, start-up, service)
- WinSPS
- WinDP
- DSS / Drive Top
- BT-MADAP / MMIMADAP
|
|
Examples of Courses:
EcoDrive / DIAX / Servodyn-D Start-up (1 day):
Start-up and optimisation of drives.
- Introduction to Drive Top / DSS operation tool.
- Configuring parameters.
- Start-up of an axis with DriveTop / DSS.
- Saving the parameters.
EcoDrive with Profibus DP on PCL, Start-up (1 day):
Learning about the control of the EcoDrive with Profibus DP.
- Selection of the drive protocol.
- Configuration of the Profibus DP parameters in the drive and control.
- Creation of simple basic control modules (PCL).
- Start-up of an axis with DriveTop / DSS.
|
|
PCL Users (1 day):
For participants with SPS experience, using a PC based PCL for the first time. Use of the programming software, PCL scope of performance and learning about available modules.
- Introduction to the WinSPS programming software.
- Hardware scope of the PCL.
- Configuration of the PCL.
- Modules
- Firmware tools (e.g. step chain firmware)
- Presentation of MMI-MADAP.
Contact partner:
Walter Bhend
Telephone +41 (0)55 46 46 379
Telefax +41 (0)55 46 46 265
walter.bhend@boschrexroth.ch
|
|
|
| |
| |
|
|
|
